05-10-2020, 09:00 PM
Hi there,
I'm trying to use Moode to run my rpi music server, the trick is that I'm using ALSA + Charlie Laub's ACD LADSPA plugins. So I set up a alsa config at /etc/asound.conf, which makes it the 'default' output. This config runs my EQ and handles crossover. Audio then goes to an old HT receiver via HDMI.
This all works well with ecasound.
both work just fine.
But I can't get the output from MPD to route through the same output, it just goes to the hw0,0 output (direct to HDMI)
I've tried updating MPD.conf, but not joy with doing that either, and mpd.conf gets overwritten every reboot anyway.
any thoughts?
I'm trying to use Moode to run my rpi music server, the trick is that I'm using ALSA + Charlie Laub's ACD LADSPA plugins. So I set up a alsa config at /etc/asound.conf, which makes it the 'default' output. This config runs my EQ and handles crossover. Audio then goes to an old HT receiver via HDMI.
This all works well with ecasound.
Code:
ecasound ~/downloads/test.flac
ecasound ~/downloads/test.flac -o defaultboth work just fine.
But I can't get the output from MPD to route through the same output, it just goes to the hw0,0 output (direct to HDMI)
I've tried updating MPD.conf, but not joy with doing that either, and mpd.conf gets overwritten every reboot anyway.
any thoughts?
