05-14-2020, 10:36 AM
Hello
Thank you both for your replies.
I noticed that if i moved the PI and the button away from the amp the problem didnt occur.
I had the button on quite a long bit of wire (30cm+) so i cut it right down to <5cm, refitted it and that solved the problem.
I think the button wire was acting as some sort of ariel and was picking up interference when the amp was turned on/ off.
Lesson learnt - keep wires short.
Cheers
Paul
Thank you both for your replies.
I noticed that if i moved the PI and the button away from the amp the problem didnt occur.
I had the button on quite a long bit of wire (30cm+) so i cut it right down to <5cm, refitted it and that solved the problem.
I think the button wire was acting as some sort of ariel and was picking up interference when the amp was turned on/ off.
Lesson learnt - keep wires short.
Cheers
Paul
