05-19-2020, 12:26 AM
(05-18-2020, 07:33 AM)Stilian Wrote: Hello Team!
I am enjoying Moode with Raspberry Pi3 and Hifiberry DIGI+ PRO. Up to now the PI's power (5V) is decoupled from the DIGI and the DIGI is fed by a separate LPS 3.3V, which is also completely disconnected from the PI. This is solved by a little barbarian approach by cutting/bending all PI's pins on the GPIO connector, which carry any power or ground. No 5V is used on the DIGI, as I do not need the optical out.
<snip>
Best Regards,
Stilian
You're using the P6 connector to feed a DAC ?
I've tried this but moved on to another hat before doing anything about powering...perhaps I should revisit it.
Instead of bending pins I might just use an extender and snip pins on that.
What are you using for the 3v3 supply ? AMS1117 or something else?
Cheers,
bob
----------
bob
bob
