06-15-2020, 11:30 PM
Hi. New user of MoodeAudio, and really liking the playback quality so far. But, I could use a hand ...
I am using the HiFiBerry digi+io hat with a raspberry pi4b and MoodeAudio. I am trying to use this setup to record my vinyl collection from a digital receiver I have that has a very nice A/D converter in it.
If I feed a toslink or s/pdif coax signal in and use “arecord” with a 16 bit 44.1khz source signal and the S16_LE specifier, everything works fine into a wav file; it sounds good and I can play it with e.g., VLC. If I use a 24 bit 96khz source signal with the S24_LE specifier, toslink will record but the music is buried under wide band noise and plays slow. The coax input acts as if there is no signal. Only the S24_LE and S16_LE specifiers are available, so I can't try any of the other formats I have seen some people recommend.
Any advice? Has anybody gotten the digi+ I/O to work with 24/96 inputs
Thanks much!
I am using the HiFiBerry digi+io hat with a raspberry pi4b and MoodeAudio. I am trying to use this setup to record my vinyl collection from a digital receiver I have that has a very nice A/D converter in it.
If I feed a toslink or s/pdif coax signal in and use “arecord” with a 16 bit 44.1khz source signal and the S16_LE specifier, everything works fine into a wav file; it sounds good and I can play it with e.g., VLC. If I use a 24 bit 96khz source signal with the S24_LE specifier, toslink will record but the music is buried under wide band noise and plays slow. The coax input acts as if there is no signal. Only the S24_LE and S16_LE specifiers are available, so I can't try any of the other formats I have seen some people recommend.
Any advice? Has anybody gotten the digi+ I/O to work with 24/96 inputs
Thanks much!
