Official moOde 6.7.1 support thread

[Tim Curtis]

This log entry shows card 0 is empty

Code:

20200724 114520 worker: Device raw: (0:Headphones|1:empty|2:empty|3:empty

It should look like below. Device "b1" is the HDMI port. That log was from the Pi-3B+ thats used to host the stock moOde image.

Code:

20200723 161755 worker: Device raw: (0:b1|1:Headphones|2:empty|3:empty

It's not obvious to me what's going on on your end.

Yeah, I don't know that either . I tried it with version 6.7.1 and a raspberry pi 2. same result .... probably there is something special with HDMI, with the audiojack a the transmission is ok. 

I'm now also trying with a Pi-3B+ and get back to you ....

1 Hour later: I just tried Raspberry Pi-3B+:It doesn't work for me with the HDMI on the Denon X4100W either. Again, to be clear, everything works, but no audio on the stereo (Denon X4100W) via HDMI.

Then I tried Moode 6.5.2 on the same setup (Pi-3B+) (Kernel 4.19). This version runs from the first boot perfectly with audio output over HDMI !

Try editing /boot/config.txt and comment out the lines below (put # in front of each line), then reboot

#hdmi_force_edid_audio=1
#hdmi_force_hotplug=1
#hdmi_group=1