09-09-2020, 11:54 PM
Hi Guys,
This is my first time using this software and my first time on the forum so please forgive any silly mistakes. I am running 6.7.1 on a pi 3 b+.
I am not able to get the gpio pins to carry out the instructions set in the configuration. I have set multiple pins with the instruction:
"sudo, poweroff"
This does not seem to work, regardless of if I bring this pin to 3.3V or Gnd. I have been able to SSH in to the board and use all commands from there however. Is there anything I have overlooked or has anyone got any experience with this problem before?
Thanks,
Ciarán
This is my first time using this software and my first time on the forum so please forgive any silly mistakes. I am running 6.7.1 on a pi 3 b+.
I am not able to get the gpio pins to carry out the instructions set in the configuration. I have set multiple pins with the instruction:
"sudo, poweroff"
This does not seem to work, regardless of if I bring this pin to 3.3V or Gnd. I have been able to SSH in to the board and use all commands from there however. Is there anything I have overlooked or has anyone got any experience with this problem before?
Thanks,
Ciarán
