09-10-2020, 10:16 PM
Hello,
Fresh member, fresh installation and fresh problem.
I deployed moode-r671 in my RPi3 on a 16GB sdcard. The setup is RPi3 (HDMI) -> AVR (Denon x5200)
I setup HDMI output in MPD settings.
However no audio comes out of the system. Also (if it matters, not sure what output I should expect) the screen goes completely blank after the boot sequence.
Lastly, the only error I can see in dmesg is:
Any ideas?
Fresh member, fresh installation and fresh problem.
I deployed moode-r671 in my RPi3 on a 16GB sdcard. The setup is RPi3 (HDMI) -> AVR (Denon x5200)
I setup HDMI output in MPD settings.
However no audio comes out of the system. Also (if it matters, not sure what output I should expect) the screen goes completely blank after the boot sequence.
Lastly, the only error I can see in dmesg is:
Code:
[ 8.252392] brcmfmac mmc1:0001:1: Direct firmware load for brcm/brcmfmac43455-sdio.raspberrypi,3-model-b-plus.txt failed with error -2Any ideas?
