Hello,
In August of this year I tried Moode with my Raspberry Pi 3a, and I absolutely love the system. It took me some time to get used to it and to properly setup the raspberry, but I got it to run for quite some time and splendidly.
However suddenly I'm experiencing that the raspberry Pi won't boot anymore. I suspect it has something to do with how I boot/shutdown the raspberry pi: The entire audio system (including the raspberry) is switched on-off with a 230-volt switch. Switched on usually in the morning/afternoon, and switched-off before going to bed. I fear this may have corrupted the SD card. This is the error code that I'm getting, as shown in the attachment: 'failed to isolate default target'
(Apologies for the bad picture quality, it was taken off a one-time beamer projection on a wall since I'm running the raspberry pi without peripherals)
Is there anything I can check/repair following this error?
I'm running Moode 6.7.1 on a raspberry Pi 3A.
In August of this year I tried Moode with my Raspberry Pi 3a, and I absolutely love the system. It took me some time to get used to it and to properly setup the raspberry, but I got it to run for quite some time and splendidly.
However suddenly I'm experiencing that the raspberry Pi won't boot anymore. I suspect it has something to do with how I boot/shutdown the raspberry pi: The entire audio system (including the raspberry) is switched on-off with a 230-volt switch. Switched on usually in the morning/afternoon, and switched-off before going to bed. I fear this may have corrupted the SD card. This is the error code that I'm getting, as shown in the attachment: 'failed to isolate default target'
(Apologies for the bad picture quality, it was taken off a one-time beamer projection on a wall since I'm running the raspberry pi without peripherals)
Is there anything I can check/repair following this error?
I'm running Moode 6.7.1 on a raspberry Pi 3A.
