Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Solved: No Access Point
#8
Can I ask a stupid question. I am not familiar with Access Point mode. ( not clear in my reading of the setup intructions for beginners)

My understanding: If you want to control the Rasberry Pi with your phone, without wifi access you can use Access point mode. I have only mangaed to get it in this mode once. I am still trying.
Could be a bad image /install. My SD card failed.

What I am not 100% on , I assume if my phone is connected to the Rasberry in AP mode . The rasberry will only play music it stores on a storage (usb) connected to it. It wont be able to access the internet via the phone - so radio stations wont work. Is this correct?

In AP mode, the phone connects directly with the Rasberry, not via a router and and my office/home/local wifi signal?

The reason it stores the password as a PK code is to protect it form hacking? Is this correct? I still put in the password in as normal when needed. ( Not the PK encripted password)

This would be helpful if it is included in setup instructions for beginners. I would assume most people would start with this basic setup. Rasberry,phone, and USB storage.


Attached Files Thumbnail(s)
   
Reply


Messages In This Thread
No Access Point - by paradox - 04-12-2018, 09:46 AM
RE: No Access Point - by Tim Curtis - 04-12-2018, 11:54 AM
RE: No Access Point - by LeVolatile - 03-04-2020, 09:57 PM
RE: No Access Point - by paradox - 04-13-2018, 08:43 AM
RE: No Access Point - by rikardo1979 - 04-13-2018, 08:59 AM
RE: No Access Point - by vijapra - 09-04-2018, 09:09 PM
RE: No Access Point - by Tim Curtis - 03-04-2020, 10:50 PM
RE: No Access Point - by 3dcnc - 12-11-2020, 12:24 PM
RE: No Access Point - by Tim Curtis - 12-11-2020, 01:16 PM
RE: No Access Point - by 3dcnc - 12-14-2020, 12:06 PM
RE: No Access Point - by TheOldPresbyope - 12-14-2020, 04:35 PM
RE: No Access Point - by Tim Curtis - 12-14-2020, 04:58 PM
RE: No Access Point - by 3dcnc - 12-16-2020, 11:03 AM
RE: No Access Point - by 3dcnc - 12-16-2020, 07:13 PM

Forum Jump: