Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Instruction Guide Using FLIRC and other USB input devices for remote control
#26
I think I need help...

I connected FLIRC USB to my Raspi 4 running moode 7.0.1. Triggerhappy is active, latest FLIRC firmware installed. But when I try to record the input of my remote control via command line there is absolutely no response. On my Linux laptop I have no problems with the programming of the same control.

Am I doing it wrong?
Reply


Messages In This Thread
RE: Using FLIRC and other USB input devices for remote control - by michdal - 01-05-2021, 09:41 PM

Forum Jump: