02-11-2021, 08:50 PM
(This post was last modified: 02-11-2021, 08:53 PM by TheOldPresbyope.
Edit Reason: added ETA
)
Re - my issue #1: Definitely something going on with the eero mesh network. I finally hooked up an ethernet switch to the eero near my desk (which for other reasons has always been my intention) and ran an ethernet cable over to the RPi3B+. Now all the 3A and 3B+ renderers are discoverable and connectable. Don't know yet how I'm going to debug this. The eero app is woefully short on details. Someone needs to write a "eero - the Missing Manual" like folks used to 20 years ago.
Ok, so on to the new upmpdcli. I got myself a trial subscription to Qobuz, entered the particulars into the UPnP Config of TR7.1.0 on the 3B+, and fired up BubbleDS on my Android Nexus 3A. The Qobuz library shows up in BubbleDS and the coverart for my selection shows up in the moOde WebUI. I score this as a success.
ETA: for this test, both UPnP A/V and OH services were enabled. I'm trying to get other stuff done today so will circle back later to see what different control points do with different combinations of the conf settings.
Now all I have to do is to remember to cancel the subscription before they start billing me.
Regards,
Kent
Ok, so on to the new upmpdcli. I got myself a trial subscription to Qobuz, entered the particulars into the UPnP Config of TR7.1.0 on the 3B+, and fired up BubbleDS on my Android Nexus 3A. The Qobuz library shows up in BubbleDS and the coverart for my selection shows up in the moOde WebUI. I score this as a success.
ETA: for this test, both UPnP A/V and OH services were enabled. I'm trying to get other stuff done today so will circle back later to see what different control points do with different combinations of the conf settings.
Now all I have to do is to remember to cancel the subscription before they start billing me.
Regards,
Kent
