02-16-2021, 07:07 PM
(This post was last modified: 02-16-2021, 07:08 PM by grasshopper.)
(02-15-2021, 11:28 PM)maxmayn Wrote:(02-15-2021, 07:19 PM)grasshopper Wrote:Did you setup the SPI (OLED) as well? As my setup seems to interfere if I enable spi=on in configt.txtCode:20210215 162807 worker: -- Start
20210215 162807 worker: Successfully daemonized
20210215 162807 worker: Integrity check (passed)
20210215 162808 worker: File check (OK)
20210215 162808 worker: Session loaded
20210215 162808 worker: Debug logging (OFF)
20210215 162808 worker: -- Device
20210215 162808 worker: ALSA cards: (0:DAC | 1:empty | 2:empty | 3:empty
20210215 162808 worker: Configured: (0:Audiophonics ES9028/9038 DAC | mixer:(Digital) | alsavol:0)
20210215 162808 worker: ALSA mixer actual (Digital)
20210215 162808 worker: ALSA Digital volume set to (0%)
20210215 162808 worker: -- System
20210215 162809 worker: Host (audiophonics)
20210215 162809 worker: moOde (7.0.1 2020-12-23)
20210215 162809 worker: RaspiOS (10.6)
20210215 162809 worker: Kernel (5.4.77-v7l+ #1371)
20210215 162809 worker: Platform (Pi-4B 4GB v1.1)
20210215 162809 worker: ARM arch (armv7l, 32-bit kernel)
20210215 162809 worker: MPD ver (0.22.3_p0x3)
20210215 162809 worker: CPU gov (ondemand)
20210215 162809 worker: USB boot not available
20210215 162809 worker: File system expanded
20210215 162809 worker: HDMI port off
20210215 162809 worker: -- Network
20210215 162809 worker: eth0 exists
20210215 162809 worker: eth0 wait 0 for IP address
20210215 162812 worker: eth0 wait 1 for IP address
20210215 162815 worker: eth0 wait 2 for IP address
20210215 162819 worker: eth0 wait 3 for IP address
20210215 162822 worker: eth0 wait 4 for IP address
20210215 162825 worker: eth0 address not assigned
20210215 162825 worker: wlan0 does not exist
20210215 162825 worker: no active network interface
20210215 162825 worker: -- Audio
20210215 162825 worker: MPD conf updated
20210215 162825 worker: ALSA outputs unmuted
20210215 162825 worker: ALSA card number (0)
20210215 162825 worker: Audio output (Audiophonics ES9028/9038 DAC)
20210215 162825 worker: Audio formats (S16_LE, S32_LE)
20210215 162825 worker: ALSA mixer name (Digital)
20210215 162825 worker: MPD volume control (disabled)
20210215 162825 worker: Hdwr volume controller exists
20210215 162825 worker: Max ALSA volume (100%)
20210215 162825 worker: Reset renderer active flags
20210215 162825 worker: -- MPD
20210215 162825 worker: MPD started
20210215 162826 worker: MPD accepting connections
20210215 162826 worker: Configure MPD outputs
20210215 162826 worker: MPD output 1 ALSA default (on)
20210215 162826 worker: MPD output 2 ALSA crossfeed (off)
20210215 162826 worker: MPD output 3 ALSA parametric eq (off)
20210215 162826 worker: MPD output 4 ALSA graphic eq (off)
20210215 162826 worker: MPD output 5 ALSA polarity inversion (off)
20210215 162826 worker: MPD output 6 ALSA bluetooth (off)
20210215 162826 worker: MPD output 7 HTTP stream (off)
20210215 162826 worker: MPD crossfade (off)
20210215 162826 worker: -- Feature availability
20210215 162826 worker: Source select (available)
20210215 162826 worker: Source select (source: MPD)
20210215 162826 worker: Source select (output: Audiophonics ES9028/9038 DAC)
20210215 162826 worker: Bluetooth (available)
20210215 162826 worker: Airplay renderer (available)
20210215 162826 worker: Spotify renderer (available)
20210215 162826 worker: Squeezelite renderer (available)
20210215 162826 worker: UPnP renderer (available)
20210215 162826 worker: UPnP renderer (started)
20210215 162826 worker: DLNA server (available)
20210215 162826 worker: UPnP browser (available)
20210215 162826 worker: GPIO button handler (available)
20210215 162826 worker: Stream recorder (n/a)
20210215 162826 worker: -- Music sources
20210215 162826 worker: USB sources (none attached)
20210215 163057 worker: NAS and UPnP sources (mountall initiated)
20210215 163057 worker: -- Miscellaneous
20210215 163057 worker: USB volume knob (Off)
20210215 163057 worker: USB auto-mounter (udisks-glue)
20210215 163057 worker: LED0 (Off)
20210215 163057 worker: LED1 (Off)
20210215 163057 worker: Saved MPD vol level (0)
20210215 163057 worker: Preamp volume level (0)
20210215 163057 worker: MPD volume level (0) restored
20210215 163057 worker: ALSA Digital volume (100%)
20210215 163057 worker: Auto-play (Off)
20210215 163057 worker: Maintenance interval (3 hrs)
20210215 163057 worker: Screen saver activation (Never)
20210215 163057 worker: Session permissions (OK)
20210215 163057 worker: Watchdog started
20210215 163057 worker: Ready
My unit works ok too.
No, I never bother setting up the OLED, it's all put together in the box as per instructions but I am just not interested in having a display on the box.