03-23-2021, 04:50 PM
(03-23-2021, 03:53 PM)Alaini93 Wrote: Hi,
you could go to MPD config to resample to mono, and use the new DSP to EQ high and low frequency on the left and right. (DSPs should be able to do that)
yes, after a few hours of tinkering, I had a few issues because the DSP keeps bugging out in mono.
I added a mixer to create the mono signal in DSP, then add high and low pass filters to the left and right channels.
my main issue is to create a digital crossover because the raw speaker sounds terrible without the crossover, and have no idea how to set it up properly.
