05-26-2021, 07:49 AM
The clue spotted by @TheOldPresbyope and the mention you made of there being more than one renderer with the same name in your control point both suggest something funky in your network and the UPnP discovery. The fact you also mention radio stream problems would point there also, but one thing at a time.
I recommend another full reboot but like this:
I recommend another full reboot but like this:
- Close all the control point software on all the devices on your network (i.e. any phone, computer, tablet that you have ever used as a control point).
- Shutdown all your moOde instances on the network by using the power command in the menu.
- Physically turn off all the control point devices.
- Shut down your amplifier/DAC and remove power.
- Remove the power from any RPi that was running running moOde.
- Shutdown and remove power from all your network routers.
- Wait at least one minute. Ten if you can. Give everything plenty of time to have forgotten what it was doing before it was turned off.
- ..wait
- ..wait
- When you've finished waiting, apply power to and turn on your routers/network gear. Wait long enough for them to settle down and have finished all the stuff they do.
- Reapply power to your amplifier/DAC.
- Apply power to your RPi which will boot moOde. Wait for that to settle down.
- Turn on one of your control point devices and wait for that to settle down.
- Launch your control point software on the control point device. At this point you should see only one control point named for your moOde device and hopefully everything with "Just Work ".
----------------
Robert
Robert