09-06-2018, 09:36 AM
Dear all,
I'm a newbie here in the forum. Discussions here are very helpful, unfortunately some obstacles occur.
I was installing moOde audio acc. to build recipe v2.5, everything went well except the USB HDD (SDD, 256 GB) is not recognized (maybe because formatted in FAT32). So I reinstalled using the MOS-builder and realised that all additional components (after step 13) are installed automatically. Is there a chance to prevent this and to install only the ones needed? (btw, USB HDD is still not recognized)
My guess would be to delete lines 843 to 1221 in the mosbuild_worker.sh. Is this correct? Where to put the modified mosbuild_worker.sh that it will be executed during automated install? Any further modifications required, e.g. in the mosbuild.sh?
Cheers, AnnaBlume
I'm a newbie here in the forum. Discussions here are very helpful, unfortunately some obstacles occur.
I was installing moOde audio acc. to build recipe v2.5, everything went well except the USB HDD (SDD, 256 GB) is not recognized (maybe because formatted in FAT32). So I reinstalled using the MOS-builder and realised that all additional components (after step 13) are installed automatically. Is there a chance to prevent this and to install only the ones needed? (btw, USB HDD is still not recognized)
My guess would be to delete lines 843 to 1221 in the mosbuild_worker.sh. Is this correct? Where to put the modified mosbuild_worker.sh that it will be executed during automated install? Any further modifications required, e.g. in the mosbuild.sh?
Cheers, AnnaBlume
