09-06-2018, 09:46 AM
(09-06-2018, 09:36 AM)AnnaBlume Wrote: Dear all,
I'm a newbie here in the forum. Discussions here are very helpful, unfortunately some obstacles occur.
I was installing moOde audio acc. to build recipe v2.5, everything went well except the USB HDD (SDD, 256 GB) is not recognized (maybe because formatted in FAT32). So I reinstalled using the MOS-builder and realised that all additional components (after step 13) are installed automatically. Is there a chance to prevent this and to install only the ones needed? (btw, USB HDD is still not recognized)
My guess would be to delete lines 843 to 1221 in the mosbuild_worker.sh. Is this correct? Where to put the modified mosbuild_worker.sh that it will be executed during automated install? Any further modifications required, e.g. in the mosbuild.sh?
Cheers, AnnaBlume
Hi AnnaBlume... have you done Moode>Configure>Sources>Update MPD Database.....?
This will take a little while depending on the size and number of files on your USB HD.
From what I recall if you want to leave out any components then you're on your own as it can't be certain that the build will be functional and issue free...so no support.
FWIW I have tried that and there is no advantage vs a full build.
The overhead is the same and if you look through the various config screens you will see that many of the features are opt in so not enabled by default and others can be disabled simply with a checkbox.
----------
bob
bob
