I am connected to Moode in Access Point mode and am trying to configure the connection to my WiFi Network using the procedure in the Setup Guide below:
1. CONFIGURE FOR WIFI CONNECTION
. . . . . . . . . . . . >>>>>>
- Access Point (AP) mode
a) Join network SSID=Moode, pwd=moodeaudio
b) http://moode.local
c) Menu, Configure, Network
At this point, I click the Scan button but when I drop down the SSID selection window, No SSIDs are shown.
The only way that I can get it to display available SSIDs is to resort to Ethernet Cable connection and then proceed as below.
d) Configure a wifi connection
e) Menu, Power, Restart
I would like to do this using Access Point mode because I need to take my Moode setup to a friend's home and connect to his network and demonstrate it on his Amplifier and Speakers.
Thank you for reading. All suggestions and help appreciated. - Robin
1. CONFIGURE FOR WIFI CONNECTION
. . . . . . . . . . . . >>>>>>
- Access Point (AP) mode
a) Join network SSID=Moode, pwd=moodeaudio
b) http://moode.local
c) Menu, Configure, Network
At this point, I click the Scan button but when I drop down the SSID selection window, No SSIDs are shown.
The only way that I can get it to display available SSIDs is to resort to Ethernet Cable connection and then proceed as below.
d) Configure a wifi connection
e) Menu, Power, Restart
I would like to do this using Access Point mode because I need to take my Moode setup to a friend's home and connect to his network and demonstrate it on his Amplifier and Speakers.
Thank you for reading. All suggestions and help appreciated. - Robin
