07-03-2021, 01:52 PM
Hi there,
I'm using moode 7.2.1 with a remote. That works fine.
In my Pi box I have a relay, that shuts down the amplifier, if nothing is played for three minutes.
Now I have a new amplifier, that has an standard input from bluetooth when powered on, so I have to use another remote to switch to an AUX input.
That is annoying.
I tried to use an IR sender to switch the amplifier input. That works, but the same time I can not use the Pi to receive signals from the first remote.
I learned, that there's a problem since lirc 0.10-1.
What i even tried is the post "IR remote control without LIRC" on this forum, but that does not work with my remotes.
Is there anybody, who has a functioning setup for Lirc 0.10-1 with a sender and a receiver?
Thanks a lot,
Uli
I'm using moode 7.2.1 with a remote. That works fine.
In my Pi box I have a relay, that shuts down the amplifier, if nothing is played for three minutes.
Now I have a new amplifier, that has an standard input from bluetooth when powered on, so I have to use another remote to switch to an AUX input.
That is annoying.
I tried to use an IR sender to switch the amplifier input. That works, but the same time I can not use the Pi to receive signals from the first remote.
I learned, that there's a problem since lirc 0.10-1.
What i even tried is the post "IR remote control without LIRC" on this forum, but that does not work with my remotes.
Is there anybody, who has a functioning setup for Lirc 0.10-1 with a sender and a receiver?
Thanks a lot,
Uli
