CamillaDSP forgets the filter settings after reboot

[bitlab]

The quick convolution config generates a config called "Quick convolution filter". That configuration shouldn't be edit by hand or with the pipeline editor, because it will be overwrite by moOde. So that explains a little bit of the behaviour you are experiencing.

But the main issue is here of course that the quick convolution config shouldn't have problems.
Based on your screenshot I see that fragments of an old template config (the warning about __IR_FORMAT__) which was used with moOde 7.2 not with 7.3.

To be sure that you have used it way it is excepted; steps are below.
First will we check the basic functionality.
Next we will regenerate the quick convolution config (to see it it was up2date or something is wrong with the template).

basic check:

1. open the moode camilladsp config page
   
2. select the "flat" configuration
   
3. press save
   
4. and play some music
   

next:

1. open the moode camilladsp config page again
   
2. select the "Quick convolution filter" configuration
   
3. set the correct Quick convolution filter configuration: gain/ir left /ir right/ format (don't use the pipeline editor!)
   
4. press save
   
5. and play some music
   

If this didn't go well, please lets us know:

• if you still get the messages about the __IR__FORMAT__
  
• is moode fresh installed or updated
  
• did you restore any files after the install /update like /usr/share/camilladsp
  

-----------------------------------------------------------------------------------------------------------------
@Tim Curtis to be sure; expected is that the in place update also has updated the following files:

• /usr/share/camilladsp/__config_template__.yml  
  
• /usr/share/camilladsp/__quick_convolution__.yml
  

Can you confirm?