07-14-2021, 09:21 PM
(This post was last modified: 07-14-2021, 09:37 PM by Sehnsucht.
Edit Reason: add space around colon to avoid a smiley appearing
)
(07-14-2021, 05:42 PM)jonners Wrote: @Sehnsucht
Just follow the guide in the first post of the following thread and enable a 'Quick Convolution Filter': http://moodeaudio.org/forum/showthread.php?tid=3617
Camilla in Moode 7.3 should accept .wav files so there is no need to convert them.
Sadly, I'm not getting anywhere. The first post says essentially to:
download the .wav
upload to convolution file
hit convert
apply to l & r in Quick Convolution filter
get green tick
click save
I've uploaded the wav.
There's no convert anywhere. You say it should accept .wav so ignore that step.
Apply the same .wav (i just uploaded) to ir left/right in the quick convolution filter section. I set ir type to wave.
I click save. I now see "version : segmentation fault" above the save button. (Rebooting and setting configuration in General to off doesn't remove this message. Maybe it's always there?).
Do i need to set pipeline configuration?
Do I need to set Configuration to quick convolution filter, seeing as that's what i'm doing after uploading the .wav? I don't hear any music and there's a red cross under camilladsp on the audio config page. But there's always a red cross under ir type in quick convolution filter.
This is on the latest moOde on a pi zero w. Parametric eq was working fine before. I've tried all 3 available .wav files for the hd 595 headphones from the autoeq github page. There's nothing very exciting in /varlog/syslog or daemon.log, or /var/log/mpd/log.
Some relevant (?) bits from system info:
moOde release = 7.3.0 2021-06-25
RaspiOS = 10.6
Linux kernel = 5.4.77+ #1371
Platform = Pi-Zero W 1.1 512MB
Architecture = armv6l (32-bit)
Parametric EQ = Off
Graphic EQ = Off
CamillaDSP = __quick_convolution__.yml
