Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Rpi 4b in to Topping D10 for car audio (airplay)
#5
Thx for the reactions!

At the moment I’m not testing in my car but with 240V and an iPhone power brick.
So I don’t think power is an issue but will change to iPad Pro charger just to be sure.
All cables used are about 2 feet, no idea about the gauge of the wire.
I’m using this funny cable as on and off switch and power cable.
https://www.123-3d.nl/123-3D-USB-C-kabel...16066.html

When MoOde is running and I attach the d10 and select the d10 in settings, it looks like its working.
The d10 says 44.1, but when I restart the pi I get the loop.
I can see command lines with numbers scrolling by but when lines that start with 4, it starts over again and again.
As I unplug the d10 the command lines pass the 4 and all is well.

For car use I have an Anker usb charger that is rated at 19W. (By anker that is)
And Topping says that the d10 uses less than 0,5A when using as usb to optical converter.
So I don’t think power is an issue but will use the iPad usb c power brick and a different usb c cable just to be sure.

Could the d10 be the issue?
In my current car setup no issues with the d10!
Update the d10? I’m not even sure these have an update available?
Reply


Messages In This Thread
RE: Rpi 4b in to Topping D10 for car audio (airplay) - by Ride154 - 07-18-2021, 09:59 AM

Forum Jump: