[PROBLEM] 3.5mm headphone Jack no output

[AZZEA]

Hi,

I am also new to moOde.  I successfully used this discussion to initially set up my headphone jack for output and it was working ... for a while.  Now there is no output from the 3.5mm and the only option available at Configure -> Audio Configure -> MPD Config -> Output Device is "Nothing Selected".

Here is my moodeutl -l output:

Code:

20210719 183849 worker: -- Start
20210719 183849 worker: Successfully daemonized
20210719 183850 worker: Integrity check (passed)
20210719 183851 worker: File check (OK)
20210719 183852 worker: Session vacuumed
20210719 183852 worker: Session loaded
20210719 183852 worker: Debug logging (OFF)
20210719 183852 worker: -- Audio debug
20210719 183852 worker: ALSA cards: (0:empty | 1:empty | 2:empty | 3:empty
20210719 183852 worker: MPD config: (0: | mixer:(PCM) | card:0)
20210719 183852 worker: WARNING: No device found at MPD configured card 0
20210719 183852 worker: -- System
20210719 183854 worker: Host     (moode)
20210719 183854 worker: moOde    (7.3.0 2021-06-25)
20210719 183854 worker: RaspiOS  (10.6)
20210719 183854 worker: Kernel   (5.4.77-v7+ #1371)
20210719 183854 worker: Platform (Pi-3B+ 1.3 1GB)
20210719 183854 worker: ARM arch (armv7l, 32-bit kernel)
20210719 183854 worker: MPD ver  (0.22.8_p0x3)
20210719 183854 worker: CPU gov  (ondemand)
20210719 183854 worker: USB boot enabled
20210719 183854 worker: File system expanded
20210719 183854 worker: HDMI port off
20210719 183854 worker: -- Network
20210719 183854 worker: eth0 exists
20210719 183854 worker: eth0 wait 0 for IP address
20210719 183855 moode.php: MPD connect failed: cmd=(loadlib)
20210719 183857 worker: eth0 wait 1 for IP address
20210719 183900 worker: eth0 wait 2 for IP address
20210719 183945 worker: eth0 wait 3 for IP address
20210719 183948 worker: eth0 wait 4 for IP address
20210719 183951 worker: eth0 address not assigned
20210719 183951 worker: wlan0 exists
20210719 183951 worker: wifi country (CA)
20210719 183951 worker: wlan0 trying SSID (BELL520)
20210719 183951 worker: IP addr (192.168.2.27)
20210719 183951 worker: Netmask (255.255.255.0)
20210719 183951 worker: Gateway (192.168.2.1)
20210719 183951 worker: Pri DNS (192.168.2.1)
20210719 183951 worker: Domain  (home)
20210719 183951 worker: Pi integrated wlan0 power save disabled
20210719 183951 worker: -- Audio config
20210719 183951 worker: ALSA card number (0)
20210719 183951 worker: MPD audio output ()
20210719 183951 worker: WARNING: No device found at MPD configured card 0
20210719 183951 worker: ALSA mixer name (PCM)
20210719 183951 worker: MPD volume control (software)
20210719 183951 worker: Hdwr volume controller exists
20210719 183951 worker: Max ALSA volume (100%)
20210719 183951 worker: ALSA output mode (Default: plughw)
20210719 183951 worker: ALSA loopback (On)
20210719 183951 worker: Reset renderer active flags
20210719 183951 worker: CamillaDSP (off)
20210719 183951 worker: -- MPD startup
20210719 183952 worker: MPD started
20210719 183953 worker: MPD accepting connections
20210719 183953 worker: MPD output 1 ALSA Default (on)
20210719 183953 worker: MPD output 2 ALSA Bluetooth (off)
20210719 183953 worker: MPD output 3 HTTP Server (off)
20210719 183953 worker: MPD crossfade (off)
20210719 183953 worker: MPD ignore CUE files (yes)
20210719 183953 worker: -- Feature availability
20210719 183953 worker: Source select (available)
20210719 183953 worker: Source select (source: MPD)
20210719 183953 worker: Source select (output: )
20210719 183953 worker: Bluetooth (available)
20210719 183953 worker: Airplay renderer (available)
20210719 183953 worker: Spotify renderer (available)
20210719 183953 worker: Squeezelite (available)
20210719 183953 worker: RoonBridge renderer (not installed)
20210719 183953 worker: UPnP renderer (available: started)
20210719 183953 worker: DLNA server (available: started)
20210719 183954 worker: UPnP browser (available: started)
20210719 183954 worker: GPIO button handler (available)
20210719 183954 worker: Stream recorder (n/a)
20210719 183954 worker: -- Music sources
20210719 183954 worker: USB source (00FA-13C8)
20210719 183954 worker: USB source (00FA-13C8_)
20210719 183954 worker: USB source (00FA-13C8__)
20210719 183954 worker: USB source (00FA-13C8___)
20210719 183954 worker: USB source (Extreme SSD)
20210719 183954 worker: USB source (Extreme SSD_)
20210719 183954 worker: USB source (Extreme SSD__)
20210719 183954 worker: USB source (Extreme SSD___)
20210719 183954 worker: USB source (Extreme SSD____)
20210719 183954 worker: NAS and UPnP sources (none configured)
20210719 183954 worker: -- Other
20210719 183954 worker: USB volume knob (Off)
20210719 183954 worker: Shellinabox SSH started
20210719 183954 worker: USB auto-mounter (udisks-glue)
20210719 183954 worker: LED0 (On)
20210719 183954 worker: LED1 (On)
20210719 183954 worker: Saved MPD vol level (0)
20210719 183954 worker: Preamp volume level (0)
20210719 183954 worker: MPD volume level (0) restored
20210719 183954 worker: ALSA PCM volume (amixer: Unable to find simple control 'PCM',0)
20210719 183954 worker: Auto-play (Off)
20210719 183954 worker: Maintenance interval (3 hours)
20210719 183954 worker: Screen saver activation (Never)
20210719 183954 worker: Session permissions (OK)
20210719 183954 worker: Watchdog started
20210719 183954 worker: Ready

I have attempted to tweak various settings without any luck. Any assistance would be appreciated.

Thanks