[SOLVED] No audio from HiFiBerry Digi(Digi+)

[Peterspieg]

In Audio Config under the I2S Audio Device section set the Named device to your particular Hifiberry card and then reboot. You can verify that the configuration is correct by examining /boot/config.txt. It should contain the line below.

Code:

dtoverlay=hifiberry-digi

Hello Tim,

thanks for your explanation. In the config.txt there is indeed

Code:

dtoverlay=hifiberry-digi

Could you tell me what the diiference is beteen "Named device" and DT overlay". I can set only one of these.
So, for now I have selected DT overlay: hifiberry-digi. Then, after reboot, there is light at the TOS-link.
So, I guess this is ok.

But, still no audio. Maybe there is another issue, in the amplifier.
I will investigate further.

Regards, Peter