10-21-2021, 05:30 PM
(This post was last modified: 10-21-2021, 05:30 PM by Tim Curtis.)
Thats an old help text on Audio Config "NOTE: Requires Loopback to be ON." Only the Sender requires Loopback and thats indicated on Multiroom Config. I'll remove the line for 7.5.0.
If the SET button is disabled and won't respond to clicks then it's prolly because the audio device does not support Hardware volume. There's a help line under the button "The Receiver requires an audio device that supports Hardware volume."
If the audio device supports Hardware volume there will be a "Hardware" selection in the dropdown list for Mixer type on MPD Config.
What audio device are you using on the Receivers?
If the SET button is disabled and won't respond to clicks then it's prolly because the audio device does not support Hardware volume. There's a help line under the button "The Receiver requires an audio device that supports Hardware volume."
If the audio device supports Hardware volume there will be a "Hardware" selection in the dropdown list for Mixer type on MPD Config.
What audio device are you using on the Receivers?
