Hi all,
I'm always looking to improve sound quality and trying to do that for the Spotify renderer as well. But I struggle a bit with how to select best settings for my hardware.
I have two RPi's, both connected to an USB DAC (a Peachtree audio decco65 dac/amplifier and a Highres microstreamer).
Not sure if you can see the attached picture, but in Spotify Config I set bitrate to 320 and the audio format to S24 as the DAC is 24bit. However I'm doubting a bit if the latter setting is correct. How to I find out the max output format my DAC supports?
I've tried suggestions like aplay -L and librespot --device ? commands in terminal but they do not give me a supported format.
Any suggestions how to proceed on this one, many thanks for your support in advance!
I'm always looking to improve sound quality and trying to do that for the Spotify renderer as well. But I struggle a bit with how to select best settings for my hardware.
I have two RPi's, both connected to an USB DAC (a Peachtree audio decco65 dac/amplifier and a Highres microstreamer).
Not sure if you can see the attached picture, but in Spotify Config I set bitrate to 320 and the audio format to S24 as the DAC is 24bit. However I'm doubting a bit if the latter setting is correct. How to I find out the max output format my DAC supports?
I've tried suggestions like aplay -L and librespot --device ? commands in terminal but they do not give me a supported format.
Any suggestions how to proceed on this one, many thanks for your support in advance!
