I agree. It's that way on all the devices as well. Those started again with fresh images for I think it was 8.2.0 64 bit. I've only been able to use the synced volume with multi-room. So no go.
Network infrastructure wise, I run a full ubiquity shop. The sender is plugged into a switch, all receivers are wifi. All on the same vlan.
I haven't tweaked anything btw, just install your general base images, then do the updates as they come out.
Is there an on device ssh command I can try to see if I can set it? Idk, I'm totally grasping as this point.
I'm happy to re-flash too. IDK, I've even re-flashed and not restored from backup, with a FRESH config and have the same issue.
Network infrastructure wise, I run a full ubiquity shop. The sender is plugged into a switch, all receivers are wifi. All on the same vlan.
I haven't tweaked anything btw, just install your general base images, then do the updates as they come out.
Is there an on device ssh command I can try to see if I can set it? Idk, I'm totally grasping as this point.
I'm happy to re-flash too. IDK, I've even re-flashed and not restored from backup, with a FRESH config and have the same issue.
