[PROBLEM] IR HAT power on/off - configuration

[Nutul]

The vendor Wiki has neither schematic nor logic diagram for this board that I could find. That's what I mean by "I don't see an obvious way...." It could be as simple as a time-out circuit (likely) or something as complicated as a handshake-driven state machine (doubt it). Someone who has one will have to experiment.

Regards,
Kent

Hi Kent,

yes, I was just wandering around with my brains... I think the IR turns the pin 5 on, then everything begins... can we give it a try, say, using some "gpio write(5, 1)" or similar from command line? (if there is such a call, of course)... I mean, just for fun's sake :-)

Cheers, Al.