Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


[HowTo] Creative BT-W2 USB-Bluetooth Audio adapter
#7
(10-11-2018, 07:01 AM)aBrianH Wrote: Did you ever decide if aptX is in use? I am interested to explore feeding a Naim MU-so with something quality. I tried DLNA and that sounds good. AptX might be close I am thinking and keep Moode player as the source.

Sorry for the delay in responding. I've been out of town.

In short, no. Since it's a USB device so far as Linux is concerned, my go-to BT tools like bluetoothctl and hcidump are useless. I'm not going to spend $100+ for a device like Ubertooth One to passively/promiscuously sniff BT packets over the air, capture them to file, and then wade through them with kismet. The response from Creative Technology to another user who asked "how can I be sure" was basically, if the remote device supports AptX, then it "just works."

At some point I'll try A/B tests listening to my Sennheiser headphones first connected via the BT-W2 (should be AptX) and then connected via the RPi BT transceiver (for sure will be SBC). Haven't had time yet.

Regards,
Kent
Reply


Messages In This Thread
RE: [HowTo] Creative BT-W2 USB-Bluetooth Audio adapter - by TheOldPresbyope - 10-15-2018, 04:52 PM

Forum Jump: