Thank you for your donation!


Cloudsmith graciously provides open-source package management and distribution for our project.


Booting from NVMe drive (In Argon40 case)
#18
(02-18-2023, 12:14 PM)Tonewheelkev Wrote: Still stuck with this!
Occurs that the *new* NVMe SSD....is straight out of the packet...un-named...and un-formatted.
Could this be why the Pi doesn't seem to be seeing the drive?

Would it help if I posted logs?
Under Music Sources...I can still see The Transcend1TB drive....even though this is not currently attached

~ $ moodeutl -l
20230218 120504 worker: --
20230218 120504 worker: -- Start moOde 8 series
20230218 120504 worker: --
20230218 120504 worker: Successfully daemonized
20230218 120507 worker: File check (OK)
20230218 120507 worker: Session vacuumed
20230218 120507 worker: Session loaded
20230218 120507 worker: Debug logging (OFF)
20230218 120507 worker: --
20230218 120507 worker: -- Audio debug
20230218 120507 worker: --
20230218 120507 worker: ALSA cards: (0:b1 | 1:Headphones | 2:E30 | 3:empty
20230218 120507 worker: MPD config: (2:E30 | mixerSadE30 ) | card:2)
20230218 120507 worker: ALSA mixer actual (E30 )
20230218 120508 worker: ALSA E30 volume set to (0%)
20230218 120508 worker: --
20230218 120508 worker: -- System
20230218 120508 worker: --
20230218 120509 worker: Host      (moode)
20230218 120510 worker: moOde     (8.2.5 2023-01-20)
20230218 120510 worker: RaspiOS   (11.5)
20230218 120510 worker: Kernel    (5.15.84-v8+ #1613)
20230218 120510 worker: Platform  (Pi-4B 1.5 4GB)
20230218 120510 worker: ARM arch  (aarch64, 64-bit)
20230218 120510 worker: MPD ver   (0.23.11)
20230218 120510 worker: CPU gov   (ondemand)
20230218 120510 worker: USB boot  (enabled)
20230218 120510 worker: File sys  (expanded)
20230218 120510 worker: HDMI port (Off)
20230218 120510 worker: Sys LED0  (On)
20230218 120510 worker: Sys LED1  (On)
20230218 120510 worker: --
20230218 120510 worker: -- Network
20230218 120510 worker: --
20230218 120510 worker: eth0 adapter exists
20230218 120510 worker: eth0 check for address (Off)
20230218 120510 worker: eth0 address not assigned
20230218 120510 worker: wlan0 adapter does not exist
20230218 120510 worker: apd0 router mode (Off)
20230218 120510 worker: No active network interface
20230218 120510 worker: --
20230218 120510 worker: -- Software update
20230218 120510 worker: --
20230218 120510 worker: Automatic check (On)
20230218 120510 worker: Unable to check: No IP address or AP mode is On
20230218 120510 worker: --
20230218 120510 worker: -- Audio config
20230218 120510 worker: --
20230218 120510 worker: MPD conf update skipped (USB device)
20230218 120510 worker: ALSA card number (2)
20230218 120510 worker: MPD audio output (E30)
20230218 120510 worker: Audio formats (S32_LE, SPECIAL, DSD_U32_BE)
20230218 120510 worker: ALSA mixer name (E30 )
20230218 120510 worker: MPD mixer type (fixed 0dB)
20230218 120510 worker: Hdwr volume controller exists
20230218 120510 worker: Max ALSA volume (80%)
20230218 120510 worker: ALSA output mode (Default: plughw)
20230218 120510 worker: ALSA loopback (Off)
20230218 120510 worker: Reset renderer active flags
20230218 120510 worker: CamillaDSP (off)
20230218 120510 worker: --
20230218 120510 worker: -- File sharing
20230218 120510 worker: --
20230218 120510 worker: SMB file sharing (Off)
20230218 120510 worker: NFS file sharing (Off)
20230218 120510 worker: --
20230218 120510 worker: -- MPD startup
20230218 120510 worker: --
20230218 120510 worker: MPD started
20230218 120510 worker: MPD accepting connections
20230218 120510 worker: MPD output 1 ALSA Default (On)
20230218 120510 worker: MPD output 2 ALSA Bluetooth (Off)
20230218 120510 worker: MPD output 3 HTTP Server (Off)
20230218 120510 worker: MPD crossfade (off)
20230218 120510 worker: MPD ignore CUE files (yes)
20230218 120510 worker: --
20230218 120510 worker: -- Music sources
20230218 120510 worker: --
20230218 120510 worker: USB sources
20230218 120511 worker: Transcend1TB
20230218 120511 worker: NAS sources
20230218 120511 worker: None configured
20230218 120511 worker: --
20230218 120511 worker: -- Feature availability
20230218 120511 worker: --
20230218 120511 worker: Input select (available)
20230218 120511 worker: Input (MPD)
20230218 120511 worker: Output (E30)
20230218 120511 worker: Bluetooth (available)
20230218 120511 worker: AirPlay renderer (available)
20230218 120511 worker: Spotify renderer (available)
20230218 120511 worker: Squeezelite (available)
20230218 120511 worker: RoonBridge renderer (not installed)
20230218 120511 worker: Multiroom sender (available)
20230218 120511 worker: Multiroom receiver (available)
20230218 120511 worker: UPnP renderer (available)
20230218 120511 worker: DLNA server (available: started)
20230218 120511 worker: GPIO button handler (available)
20230218 120511 worker: Stream recorder (n/a)
20230218 120511 worker: HTTPS-Only mode (n/a)
20230218 120511 worker: --
20230218 120511 worker: -- Other
20230218 120511 worker: --
20230218 120511 worker: USB volume knob (Off)
20230218 120511 worker: LCD updater engine started
20230218 120511 worker: Shellinabox SSH started
20230218 120511 worker: USB auto-mounter (udisks-glue)
20230218 120511 worker: Saved MPD vol level (0)
20230218 120511 worker: Preamp volume level (0)
20230218 120511 worker: MPD volume level (0) restored
20230218 120511 worker: ALSA E30 volume (80%)
20230218 120511 worker: Auto-play (Off)
20230218 120511 worker: LocalUI (Off)
20230218 120511 worker: Automatic CoverView (Off)
20230218 120511 worker: On-screen keyboard (Off)
20230218 120511 worker: Library scope (all)
20230218 120511 worker: View reset to playback
20230218 120511 worker: Maintenance interval (360 minutes)
20230218 120511 worker: Screen saver activation (Never)
20230218 120511 worker: Session permissions (OK)
20230218 120511 worker: Mount monitor (Off)
20230218 120511 worker: Watchdog started
20230218 120511 worker: Ready

and running lsblk now gives:

 $ lsblk
NAME        MAJ:MIN RM   SIZE RO TYPE MOUNTPOINT
sda           8:0    1 931.5G  0 disk
mmcblk0     179:0    0  29.1G  0 disk
├─mmcblk0p1 179:1    0   256M  0 part /boot
└─mmcblk0p2 179:2    0  28.9G  0 part /

Looks like it can see the device sda but no partition on it.

Code:
pi@somebox:~ $ sudo lsblk
NAME        MAJ:MIN RM  SIZE RO TYPE MOUNTPOINT
sda           8:0    0  3.6T  0 disk 
└─sda1        8:1    0  3.6T  0 part /media/USB4tbMusic
mmcblk0     179:0    0 29.7G  0 disk 
├─mmcblk0p1 179:1    0  256M  0 part /boot
└─mmcblk0p2 179:2    0 29.5G  0 part /

Is there anything in /var/log/syslog relating to a failure to mount one?

Code:
pi@somebox:~ $ sudo blkid
/dev/mmcblk0p1: LABEL_FATBOOT="boot" LABEL="boot" UUID="A248-68DA" BLOCK_SIZE="512" TYPE="vfat" PARTUUID="86ac5767-01"
/dev/mmcblk0p2: LABEL="rootfs" UUID="2c4ec460-c619-4347-ba40-ca4b1780056e" BLOCK_SIZE="4096" TYPE="ext4" PARTUUID="86ac5767-02"
/dev/sda1: LABEL="USB4tbMusic" UUID="2577a29d-d425-4f6e-a43b-b79a95ed503b" BLOCK_SIZE="4096" TYPE="ext4" PARTUUID="e2fe89d7-142f-4649-9f62-c1d671e3640f"


Probably unrelated but slightly odd perhaps that you have RaspiOS 11.5 and mine's 11.6 but we're both on the same version of moOde.  I've made a few changes to my install for infra-red support but I've not run apt-get upgrade. Maybe the different "Platform" explains it.


Code:
20230218 111024 worker: moOde     (8.2.5 2023-01-20)
20230218 111024 worker: RaspiOS   (11.6)
20230218 111024 worker: Kernel    (5.15.84-v8+ #1613)
20230218 111024 worker: Platform  (Pi-4B 1.1 2GB)
20230218 111024 worker: ARM arch  (aarch64, 64-bit)
20230218 111024 worker: MPD ver   (0.23.11)
Reply


Messages In This Thread
RE: Booting from NVMe drive (In Argon40 case) - by Sehnsucht - 02-18-2023, 01:50 PM

Forum Jump: