04-22-2023, 04:50 PM
(This post was last modified: 04-23-2023, 04:56 PM by Tonewheelkev.)
Here I am again!
Selected the in place update....from 8.3.0 to 8.3.2, and this time did a backup before proceeding.
After rebooting....have the same problem I experienced on attempting to update to 8.3.1 earlier this week.
I can reach the config page.....but then can't access anything on that page.
So can't even reinstate the 8.3.0 working install......
I must be doin' something wrong???
It occurs that I should add....Rpi4 connected via USB to Topping E50.....just noticed Shutdown not working either.
Selected the in place update....from 8.3.0 to 8.3.2, and this time did a backup before proceeding.
After rebooting....have the same problem I experienced on attempting to update to 8.3.1 earlier this week.
I can reach the config page.....but then can't access anything on that page.
So can't even reinstate the 8.3.0 working install......
I must be doin' something wrong???
It occurs that I should add....Rpi4 connected via USB to Topping E50.....just noticed Shutdown not working either.
