Thank you for your donation!
|
motor encoder controlled volume pot
|
07-06-2023, 03:42 PM
Naw, I gave up my CNC gear long ago: 2-axis lathe, 3-axis mill, 3D printing, plus experimental stuff. For quite awhile I also mentored high school robotics teams but typically their ‘bots were closer to RC-systems than to CNC.
I’m quite satisfied with volume control in software or my DAC. Regards, Kent |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
motor encoder controlled volume pot - by Bedlore - 07-06-2023, 01:30 PM
RE: motor encoder controlled volume pot - by Tim Curtis - 07-06-2023, 01:41 PM
RE: motor encoder controlled volume pot - by Bedlore - 07-06-2023, 02:33 PM
RE: motor encoder controlled volume pot - by Tim Curtis - 07-06-2023, 08:10 PM
RE: motor encoder controlled volume pot - by TheOldPresbyope - 07-06-2023, 02:04 PM
RE: motor encoder controlled volume pot - by Bedlore - 07-06-2023, 02:38 PM
RE: motor encoder controlled volume pot - by TheOldPresbyope - 07-06-2023, 03:42 PM
|
