07-07-2023, 08:20 PM
Sorry for the dummy post above!
Good info on the supplemental caps. I'll give it a try on my next (soon) build. A question for a bit of context: I'm assuming that the two electrolitics are in parallel forming a compound capacitance? So any bypass is bypassing both electrolytics and the only complicating issues might be the short leads and traces combining them? Is it safe to say that any combination of 1+ capacitors at or somewhat less than 2K uf meets the general electrical design need?
I, too am using a filter, the realtively new Pass full range active EQ board and it complements the DAC nicely allowing a better match with the Alpair 11MS drivers in small Nostromo boxes. I may flatten both the LF and MidHighF components slightly, but it's fairly close.
Thanks,
Skip
Good info on the supplemental caps. I'll give it a try on my next (soon) build. A question for a bit of context: I'm assuming that the two electrolitics are in parallel forming a compound capacitance? So any bypass is bypassing both electrolytics and the only complicating issues might be the short leads and traces combining them? Is it safe to say that any combination of 1+ capacitors at or somewhat less than 2K uf meets the general electrical design need?
I, too am using a filter, the realtively new Pass full range active EQ board and it complements the DAC nicely allowing a better match with the Alpair 11MS drivers in small Nostromo boxes. I may flatten both the LF and MidHighF components slightly, but it's fairly close.
Thanks,
Skip
