07-12-2023, 03:18 AM
(This post was last modified: 07-12-2023, 03:38 AM by kurek.
Edit Reason: Situation changed.
)
I've been fighting this too, glad I found this thread although I don't know that it's done me any good.
Since I had been using moode for a couple years (prior to 8.3.0) I just tried writing the image using balena etcher like I did last time and I encountered this exact problem. The first time I log in to the UI I can navigate into menus but then everything just hangs.
OK, found this thread - read the Setup Guide, used Raspberry Pi Imager and set options for ssh user/password - but the behavior is the same. I can boot up the unit, enter the web interface and click on configure but after clicking "Save" on anything it hangs and my only option is to put the sd card back into my Windows PC, delete the partitions (or Raspberry Pi Imager will fail), then rewrite the image, then experience that same failure all over again.
I'm gonna feel really stupid if it's something simple but it's not from me not reading and rereading the setup guide until my eyes melt.
And suddenly this last time it works, though I'm not sure I did anything differently.
Well.. yay! I will update my reply if I learn anything as I continue setting it up. Can't wait to have tunes again!
Since I had been using moode for a couple years (prior to 8.3.0) I just tried writing the image using balena etcher like I did last time and I encountered this exact problem. The first time I log in to the UI I can navigate into menus but then everything just hangs.
OK, found this thread - read the Setup Guide, used Raspberry Pi Imager and set options for ssh user/password - but the behavior is the same. I can boot up the unit, enter the web interface and click on configure but after clicking "Save" on anything it hangs and my only option is to put the sd card back into my Windows PC, delete the partitions (or Raspberry Pi Imager will fail), then rewrite the image, then experience that same failure all over again.
I'm gonna feel really stupid if it's something simple but it's not from me not reading and rereading the setup guide until my eyes melt.
And suddenly this last time it works, though I'm not sure I did anything differently.
Well.. yay! I will update my reply if I learn anything as I continue setting it up. Can't wait to have tunes again!
Pi 4 w/ touchscreen, multiroom to pi3b+ & pi zero2w
