ProtoDAC TDA1387 X8 project

[Skip Pack]

Nice insertion posts for the caps in your image there. Do you have a part number available?  I put a second PDAC together,  this time with the z-foil output resistors and the polycarb cap pulls I purchased from you. The improvement from the 'plain' minimal model is clear, and I'm running 24hrs a day  to get some time one it. I think I'll do the next one with the ERO MKC caps I got. Since the lead spacing is a bit short, I'm thinking about running those caps upside down running two wires down to the board, thinking it might be more stable particularly if I have to offset it at all due to the 40 GPIO pins poking up from below. 

Thanks again for all your work on this,

Skip