08-11-2023, 11:06 PM
The caps I have are consistent with the data sheet.
10uf 63V: L = 31.5, H = 20.5, W = 11.5
6.8uf 100V: L = 31.5, H = 23.5, W = 13.5
I'm curious, if you moved the row of holes/pads for the output caps 1-1.5mm inward toward the DAC chip on the side of the GPIO connector, would the assymetry vs the other side lead to capacitance or inductance issues? that offset would make it easier to make sure the 'red box' caps would have the little nibs on the corners sit on the pcb surface with that cap being more stable. Potentially it would make mounting the MKP equivalents difficult. I'm probably over-thinking this.
In any case, thanks for the new Gerbers.
Skip
10uf 63V: L = 31.5, H = 20.5, W = 11.5
6.8uf 100V: L = 31.5, H = 23.5, W = 13.5
I'm curious, if you moved the row of holes/pads for the output caps 1-1.5mm inward toward the DAC chip on the side of the GPIO connector, would the assymetry vs the other side lead to capacitance or inductance issues? that offset would make it easier to make sure the 'red box' caps would have the little nibs on the corners sit on the pcb surface with that cap being more stable. Potentially it would make mounting the MKP equivalents difficult. I'm probably over-thinking this.
In any case, thanks for the new Gerbers.
Skip
