ProtoDAC TDA1387 X8 project

[kLOkUIS]

I am not sure. The 130k resistors would generate a much higher than normal voltage at the analog outputs. I wouldn't think this would damage the module. Play a 50Hz 0dB sine wave file and measure the DC and AC voltages at pins 6 and 25 of the module with a DMM. Also, be sure the I2S resistors (R1-R3) are correct.

Thank you for the information. I should have followed your advice because maybe I would have been wiser now. But I desoldered all components (except the chip) and started on a fresh pcb.
I’m happy to report that it works beautifully now.Though I can’t give an answer if the wrong resistors kills the 8x TDA1387. It might have been a soldering error, or a bad chip from the beginning

Kind regards, Louis