01-02-2024, 01:55 AM
Hi,
When you install Moode following the official Setup Guide, Raspberry Pi Imager settings are used to activate SSH and provide a user id, password and (optionally) host name.
The Raspberry Pi Imager additionally knows settings to configure the WLAN country, time zone and keyboard layout. These settings are, however, currently ignored by Moode (version 8.3.7). Of course you can provide the respective information later when Moode is running via Configure -> Network (WLAN country) and Configure -> System (time zone & keyboard layout).
Idea: Would it be possible (i.e. without too much effort) to enhance the installation process so that it (optionally) uses the Rapberry Pi Imager settings to configure WLAN country, time zone and keyboard layout?
Thanks & best regards
Jens
When you install Moode following the official Setup Guide, Raspberry Pi Imager settings are used to activate SSH and provide a user id, password and (optionally) host name.
The Raspberry Pi Imager additionally knows settings to configure the WLAN country, time zone and keyboard layout. These settings are, however, currently ignored by Moode (version 8.3.7). Of course you can provide the respective information later when Moode is running via Configure -> Network (WLAN country) and Configure -> System (time zone & keyboard layout).
Idea: Would it be possible (i.e. without too much effort) to enhance the installation process so that it (optionally) uses the Rapberry Pi Imager settings to configure WLAN country, time zone and keyboard layout?
Thanks & best regards
Jens
