01-06-2024, 10:02 AM
Could this configuration work without conflicting with moOde + camillaDSP automatic reconfiguration behaviour?
* Put an ALSA mixer (dmix) in front of the HDMI hw device.
* Play /dev/null into the mixer (launch this after alsa is ready - where?)
* Output camillaDSP to mixer
I am not yet clear how/where to actually configure this, but if the idea is sound I'll work that out next.
(I am very happy if this requires fixing the output channels, rate & format!)
* Put an ALSA mixer (dmix) in front of the HDMI hw device.
* Play /dev/null into the mixer (launch this after alsa is ready - where?)
* Output camillaDSP to mixer
I am not yet clear how/where to actually configure this, but if the idea is sound I'll work that out next.
(I am very happy if this requires fixing the output channels, rate & format!)
- Digital source, room EQ & 3-way x-over to HDMI (6 channels):
- Pi-4B 1.5 4GB, RaspiOS 11.8 Bullseye 64-bit, moOde 8.3.7 2023-12-07
- HDMI demux, DACs & Power Amps:
- Onkyo TX-SR875 or TX-NR905 in pure/direct mode
- Speakers:
- Linn Kaber Aktiv (currently tri-amped passive)
