(02-21-2024, 03:55 AM)varunach Wrote: @hifinet I'm not able to get the Startup log because the RPi is unresponsive (can't access from browser nor SSH). But if I connect to ethernet it boots so I'm guessing the start up will look just fine. Is there another way to get the start up log from the SD card directly?
More perplexing stuff. My home has the wifi router in the living room. I'm able to connect to both ethernet and Wifi just fine when I connect to the Rpi4 ProtoDAC stack from my living room. But when I move the device stack to my office which is a bit farther and where this device is usually plugged in (about 25 feet from router) I can't connect to Wifi anymore. I also enabled 'Access Point configuration' to see if I can log in via http://172.24.1.1 if RPi4 can't connect to Wifi, but no luck. Moode interface is not accessible. This is the same location where the simple RPi4 + ProtoDac stack sat for the past month and I've been using Moode without any issues. Now with PurePi and Q7 it is acting up bizzarly. This is the same location where I have 2 Macs and 2 phones connected to Wifi and working just fine. I think I'm just gonna give up on this and chalk it up to weird internet blackhole.
I'm also wondering if there some sort of power line / ground interference in this room wall socket that is interfering with PurePi / Q7 clocks.
I have experienced the same issue as you with Q7, so I’m just playing with the ProtoDAC at the time. I don’t have the PurePi though. I have a SD card with Volumio and that works fine with WiFi even with 3.3v on the ProtoDAC from Q7. One thing to mention, I logged on my router to see if the rpi was online, and it was.
I’ve just got som parts for a new 5v PS so my plan was to try again with the Q7 this week.
