02-22-2024, 01:12 PM
(02-22-2024, 12:40 AM)Keksianer Wrote: At the beginning yes, but that was because i listened to music in 96 and 192khz (flac format).
Then i wanted to play some tracks in 44.1khz with 16bit and have no sound with it.
So i don't know at which time i had the issue, but i think it was from that moment that i installed the hifiberry digi.
I tested it again with Hifiberry DAC2 (that was the hat before) and it works fine with it.
What i did not test yet is a fresh install of moode. If that doesn't work, too, i will test install the HifiBerry OS and / or Volumio, to check it out if it is a software or hardware issue.
Edit:
I Resample with any bit depth and 48khz => Works, only Resample to 24bit => doesn't Work, so it must be the khz rate.
moOde just adds a line to /boot/config.txt for loading the correct kernel driver overlay for an I2S device, and for all hifiberry devices it adds a second line to disable reading the boards EEPROM based overlay because there was an issue in the past where some of the hifiberry EEPROM overlays were not compatible with particular Linux kernel versions.
For the digi+ pro you should see these two lines:
Code:
dtoverlay=hifiberry-digi-pro
force_eeprom_read=0In any case after a quick Google search there seem to be a lot of compatibility issues with this board.
