Upcoming moOde 9.0.0 (Bookworm)

[nosferatu_cat]

On my Pi 4 when I set a static IP all ports get closed.  With DHCP it works fine.  I haven't tried doing it from the command line.

I guess I can assume you're talking about some pre-release of r900 since you posted to this thread but I can't assume anything else. Ethernet connection? WiFi connection? Both??? Details matter.

ETA

As a followup, I just disabled the WiFi connection on my Pi4B running m900pre~5 so only there's only an Ethernet connection. Then I changed the Ethernet connection from DHCP (which had assigned the player IP = 10.0.0.122) to Static IP = 10.0.0.251 and filled in appropriate Gateway, etc., info. Rebooted.

Now, from my laptop

Code:

:~$ nmap -sT 10.0.0.251
Starting Nmap 7.80 ( https://nmap.org ) at 2024-05-05 14:25 EDT
Nmap scan report for 10.0.0.251
Host is up (0.018s latency).
Not shown: 996 closed ports
PORT     STATE SERVICE
22/tcp   open  ssh
80/tcp   open  http
111/tcp  open  rpcbind
5357/tcp open  wsdapi

Regards,
Kent

Wifi connection.  I set the static address through the networking setup screen as I always have.