06-02-2024, 05:42 AM
(06-01-2024, 03:39 PM)Venerdi Wrote:(06-01-2024, 02:01 PM)Tim Curtis Wrote: This message "** To set a new password for your userid type 'passwd'." is ok. It's how you would change your password if desired.
@Venerdi the WebUI does not automatically appear on an attached display. Open a Browser, type http://moode, http://moode.local, or http://IP_ADDRESS_OF_PI.
Menu, Configure, Peripherals has the section the Local Display, Pi Touch etc.
@Tim
Thanks, I solved the problem, but now I have two more questions to ask.
1) Until now I turned on the Pi4 and I was immediately in moOode. Now, it always asks me for login and password. How can I avoid this?
2) The picture on the TV was perfect; now, at the beginning it's full of artifacts, then it goes back to normal, but it goes partly off screen. I don't see a part on the right and the whole top part. In moOde options there is GPIO pin mappings. It can be useful?
v.
what do you mea by "always asks for user/pw"? the console/command line or when you are actually in the moode GUI? when accessing moode via a browser... under system/peripherals... is local display active?
