[SOLVED] 9.01 does not start

[Venerdi]

This message "** To set a new password for your userid type 'passwd'." is ok. It's how you would change your password if desired.

@Venerdi the WebUI does not automatically appear on an attached display. Open a Browser, type http://moode, http://moode.local, or http://IP_ADDRESS_OF_PI.

Menu, Configure, Peripherals has the section the Local Display, Pi Touch etc.

@Tim
Thanks, I solved the problem, but now I have two more questions to ask.
1) Until now I turned on the Pi4 and I was immediately in moOode. Now, it always asks me for login and password. How can I avoid this?
2) The picture on the TV was perfect; now, at the beginning it's full of artifacts, then it goes back to normal, but it goes partly off screen. I don't see a part on the right and the whole top part. In moOde options there is GPIO pin mappings. It can be useful?

v.

what do you mea by "always asks for user/pw"? the console/command line or when you are actually in the moode GUI? when accessing moode via a browser... under system/peripherals... is local display active?

Hi,
I'll try to explain myself better. The Raspberry is connected with HDMI output to the TV. When I turn on the Raspberry, on the television screen I see all the boot. Towards the end of boot, the system asks for userid and password.
When I enter them, after 2 or 3 seconds, I access the moOde GUI.
This morning, doing other checks, I realized that if I don't enter the userid and psw, after exactly 20 seconds of waiting, he enters the moOde GUI.
Unfortunately, viewing problems remain on the TV screen, the image is off-centre and too large. If I connect remotely from my PC, the image is perfect. Up until version 8.39, I didn't have this problem.
v.