06-15-2024, 04:16 PM
hey
as a continuation of (9.0.2) moOde always crashes when i try to scan my library (9) (moodeaudio.org)
i think i can narrow it down to two possible reasons for my issue:
either a defective sd card or a ram issue when scanning the library
what i can not rule out: that i have outliers within my library with unusual large cover images embedded
what i have observed: when the 7" pi display is activated and the GUI is running, it takes up more than 400mb of my 900mb ram. if it is off, moode only uses roughly 150mb
the library scan finished successfully after switching to usb boot (thus "removing" the possibly faulty sandisk sdhc card) and leaving the GUI off for the scan
summary:
what did not work: installing fresh 9.0.2, setting everything up, including the display GUI and after that scanning the library -> freeze
what worked: installing fresh 9.0.2, setting up smb connection to nas, scanning library and setting everything else up after the initial scan
for now i see my issue as resolved (as i'm sticking to leaving the gui off for the initial scan)
but i wanted to write down my suspicion - maybe only relevant to my library-outliers
as a continuation of (9.0.2) moOde always crashes when i try to scan my library (9) (moodeaudio.org)
i think i can narrow it down to two possible reasons for my issue:
either a defective sd card or a ram issue when scanning the library
what i can not rule out: that i have outliers within my library with unusual large cover images embedded
what i have observed: when the 7" pi display is activated and the GUI is running, it takes up more than 400mb of my 900mb ram. if it is off, moode only uses roughly 150mb
the library scan finished successfully after switching to usb boot (thus "removing" the possibly faulty sandisk sdhc card) and leaving the GUI off for the scan
summary:
what did not work: installing fresh 9.0.2, setting everything up, including the display GUI and after that scanning the library -> freeze
what worked: installing fresh 9.0.2, setting up smb connection to nas, scanning library and setting everything else up after the initial scan
for now i see my issue as resolved (as i'm sticking to leaving the gui off for the initial scan)
but i wanted to write down my suspicion - maybe only relevant to my library-outliers
