07-09-2024, 05:25 PM
You did reboot the Pi after you selected the DT Overlay, right?
On a Pi 4B with the Innomaker DAC Pro HAT installed and moOde 9.0.4 booted, selecting either the allo-katana-dac-audio DT Overlay or the"Allo Katana DAC" Named I2S device, and rebooting, a Output Device "2:Allo Katana" shows up in the Audio config screen.
Whether or not I actually select that Output device, I get the following from the command line
If there's no "Katana" card showing up on your player then perhaps your suspicion is right. I'd double check to make sure the board is properly seated on the Pi's GPIO pins.
Regards,
Kent
On a Pi 4B with the Innomaker DAC Pro HAT installed and moOde 9.0.4 booted, selecting either the allo-katana-dac-audio DT Overlay or the"Allo Katana DAC" Named I2S device, and rebooting, a Output Device "2:Allo Katana" shows up in the Audio config screen.
Whether or not I actually select that Output device, I get the following from the command line
Code:
rho@mpi4b:~ $ aplay -l
**** List of PLAYBACK Hardware Devices ****
card 0: vc4hdmi0 [vc4-hdmi-0], device 0: MAI PCM i2s-hifi-0 [MAI PCM i2s-hifi-0]
Subdevices: 1/1
Subdevice #0: subdevice #0
card 1: vc4hdmi1 [vc4-hdmi-1], device 0: MAI PCM i2s-hifi-0 [MAI PCM i2s-hifi-0]
Subdevices: 1/1
Subdevice #0: subdevice #0
card 2: Katana [Allo Katana], device 0: fe203000.i2s-allo-katana-codec allo-katana-codec-0 [fe203000.i2s-allo-katana-codec allo-katana-codec-0]
Subdevices: 1/1
Subdevice #0: subdevice #0If there's no "Katana" card showing up on your player then perhaps your suspicion is right. I'd double check to make sure the board is properly seated on the Pi's GPIO pins.
Regards,
Kent
