07-28-2024, 09:18 AM
(This post was last modified: 07-28-2024, 09:21 AM by sultanoswing.)
I've got my Pi4 moode plugged in to an SMSL C200 via USB. The set up works and sounds great.
I then power down the C200 DAC at the end of a listening session, but leave the Pi 4 powered on.
However, when I power on the C200 for the next session, the Pi / moode has defaulted to "0 : Pi HDMI 1", and needs a manual switch (Configure -> Audio -> Output device) back to "3: SMSL USB" every time. I don't recall this occurring under moode v8.x for what that's worth.
Is there a way to automate this e.g. by disabling the Pi HDMI outputs, or other workaround?
I then power down the C200 DAC at the end of a listening session, but leave the Pi 4 powered on.
However, when I power on the C200 for the next session, the Pi / moode has defaulted to "0 : Pi HDMI 1", and needs a manual switch (Configure -> Audio -> Output device) back to "3: SMSL USB" every time. I don't recall this occurring under moode v8.x for what that's worth.
Is there a way to automate this e.g. by disabling the Pi HDMI outputs, or other workaround?
TrueNAS scale -> Pi 4 -> SMSL C200 DAC -> Naim NAIT 2 amp -> Theophany M4 floor standers -> ears
