ProtoDAC TDA1387 X8 project

[gperpetuo]

Hi,

When soldering the TDA1387 X8 Module to the pcb, I did not notice I was soldering "mirrored". In other words, I soldered only 2 pins on the side I should have soldered 6 and soldered 6 pins on the side it was enought only 2 (25, left channel and 28, 5V).

With this, I gave 5v to the board and no GND.

Question:
With this, could I damage anything on the board? (the module was on correct position, only the pins were not connected)

I ask this because now I have a short somewhere on the board and I didn't have it prior to soldering the remaining pins, so the short is somewhere in the TDA1387 module...

Thanks,
Gonçalo Perpétuo