It's not a dead short, but a semiconductor voltage drop? It might vary with the type of meter, but with my DMM it beeps with a semiconductor and then shows voltage drop. With dead short, it beeps and then measures a resistance.
The other question I have with your module is that all the ceramic caps are the same size. Did they just use all 100nF caps to lower cost?
The seller has blank PCBs? I would like to get modules without the pins. That would make it easy to stack modules. I want to try 100R I/V resistors and four paralleled modules. I have removed pins and stacked two modules.
The TDA1387 X4 modules are back. The ones with the 1uF electrolytic pin 7 caps and 100nF film decoupling caps.
The other question I have with your module is that all the ceramic caps are the same size. Did they just use all 100nF caps to lower cost?
The seller has blank PCBs? I would like to get modules without the pins. That would make it easy to stack modules. I want to try 100R I/V resistors and four paralleled modules. I have removed pins and stacked two modules.
The TDA1387 X4 modules are back. The ones with the 1uF electrolytic pin 7 caps and 100nF film decoupling caps.
Hardware: RPi Zero W | Allo Kali | ProtoDAC TDA1387 X8 | PGA2311 | Icepower 500ASP | Harbeth SHL5
Software: Moode 8.3.3
Source: Win 10 NAS
Software: Moode 8.3.3
Source: Win 10 NAS
