11-02-2024, 07:06 PM
I was going to mention setting the "ALSA output mode" option on Receiver Config to "IEC958" but I see from the launch string that its been set (default:vc4hdmi1) but hdmi1 is the second port on the pi4. I think u need to use the 1st port (hdmi0) on the pi4 for audio, at least thats what I've always used.
Un-checking the receiver sets it on/off/disabled flag to off and then kills it. You would see "Terminated" in the debug logging. Watchdog only restarts the receiver if it flag = on and it has crashed.
Un-checking the receiver sets it on/off/disabled flag to off and then kills it. You would see "Terminated" in the debug logging. Watchdog only restarts the receiver if it flag = on and it has crashed.
