11-02-2024, 08:28 PM
Thanks Tim, this lead me in the right direction: After a restart the Pi needed to "see" the HDMI cable conneted to an active device (probably some communication or signal level check?) . But the Denon was in standby. Even the web UI tells me when starting a radio "Output is set to HDMI but no audio device was detected on the HDMI port." After shutting down my AVR the pi sometimes complains about that, sometimes not.
I am pretty sure I did not have this problem on Moode 8. I searched the web and found that there have been lots of changes going on regarding the HDMI interface with bookworm...
Anyway, I can workaround this by enabling the "hdmi passthrough" option in my AVR. I dont like it as it increases the standby current (0.1 to 0.5W), but for the time being its fine...
Unless someone has a hint on how to configure the config.txt (or nowadays also cmdline.txt) so that moode will always send audio via hdmi?
I am pretty sure I did not have this problem on Moode 8. I searched the web and found that there have been lots of changes going on regarding the HDMI interface with bookworm...
Anyway, I can workaround this by enabling the "hdmi passthrough" option in my AVR. I dont like it as it increases the standby current (0.1 to 0.5W), but for the time being its fine...
Unless someone has a hint on how to configure the config.txt (or nowadays also cmdline.txt) so that moode will always send audio via hdmi?
